Haltech Elite NSP Training Course Part 10: Trim Pot & Switch Set-Up
Haltech Elite NSP Master Training Course
•
26m
Haltech Elite NSP Training Course Part 10: Trim Pot & Switch Set-Up breaks down how to wire and configure a switched input. We also explore how to properly wire and configure a trim pot switch.
Up Next in Haltech Elite NSP Master Training Course
-
Haltech Elite NSP Training Course Par...
Haltech Elite NSP Training Course Part 11: Flex Fuel Sensor Set-Up walks you through how to properly configure and test a flex fuel sensor within the Haltech NSP software.
-
Haltech Elite NSP Training Course Par...
Haltech Elite NSP Training Course Part 12: TPS & Linear Sensors Set-Up walks you through configuring linear style sensors such as throttle position and shock travel within the NSP software.
-
Haltech Elite NSP Training Course Par...
Haltech Elite NSP Training Course Part 13: On/Off Output Control Set-Up walks you through how to properly configure basic output control using the Haltech Elite system. We explore the differences between low side and high side outputs as well as relay configurations.
