Motec M1 Training Course Part 11: i2 Logging Software Overview walks you through highlights of the i2 logging software for data analysis.

Motec M1 Training Course Part 12: Basic Set-Up goes through the basic configuration and set-up to create a custom calibration within your firmware package.

Motec M1 Training Course Part 13: Pressure Sensor Set-Up walks you through configuring and testing different types of pressure sensors within the M1 software.

Motec M1 Training Course Part 14: Temperature Sensor Set-Up walks you through how to configure a temp sensor input to the Motec M1.

Motec M1 Training Course Part 15: TPS & Linear Position Sensor Set-Up walks you through position sensor set-up and configuration within the Motec M1 software.

Motec M1 Training Course Part 16: Flex Fuel Sensor & Fuel Temp Set-Up walks you through how to set-up an ethanol content sensor within the Motec M1 software.

Motec M1 Training Course Part 17: LTC Lambda Controller Can Set-Up walks you through configuring the LTC using the Motec M1 and LTC manager software.

Motec M1 Training Course Part 18: Switch & Trim Pot Set-Up looks at how to configure a basic on/off toggle switch and multi position switch within the Motec M1 software.

Motec M1 Training Course Part 19: Output Types Overview goes through the various output types found within Motec M1 programming.

Motec M1 Training Course Part 20: On/Off Output Control Set-Up walks you through setting up basic output control in Motec M1 programming.

Motec M1 Training Course Part 21: PWM Output Control Set-Up walks you through properly configuring PWM outputs within the Motec M1 programming.

Motec M1 Training Course Part 22: Oscilloscope walks you through using the input capture feature to help diagnose cam or crank trigger inputs.

Motec M1 Training Course Part 23: Hall Effect Trigger Set-Up walks you through how to set-up and configure a hall effect cam and crank trigger input. We explore using the input capture / oscilloscope function to determine trigger patterns for programming.

Motec M1 Training Course Part 24: VR / Reluctor Trigger Set-Up walks you through how to program a reluctor cam/crank trigger. We explore using the input capture / oscilloscope to determine tooth count and wave amplitude.

Motec M1 Training Course Part 25: Engine Reference Offset walks you through how to set-up the engine reference offset to ensure the Motec M1 is in sync with the engine position.

Motec M1 Training Course Part 26: Airflow Model Overview walks you through how the airflow model works within the Motec M1 programming.

Motec M1 Training Course Part 27: Lambda, AFR, & Stoich walks you through the relationship between lambda and fuel stoich within the Motec M1 programming.

Motec M1 Training Course Part 28: VE Table Set-Up walks you through how to configure a VE table for a naturally aspirated and forced induction engine.

Motec M1 Training Course Part 29: Lambda Aim Table Set-Up walks you through how to properly configure the lambda target table for naturally aspirated and forced induction engines.

Motec M1 Training Course Part 30: Inlet Manifold Estimate Table Tuning walks you through how to dial in the estimate table for MAP sensor fail safe operation.

Motec M1 Training Course Part 31: Alpha-N Tuning walks you through how to dial in ITBs properly using the estimate table in Motec M1 programming.

Motec M1 Training Course Part 32: Forced Induction Alpha-N Tuning walks you through how to dial in ITBs with forced induction using the estimate table tuning.

Motec M1 Training Course Part 33: Fuel Injector Characterization breaks down injector flow reference, latency, and short pulse-width data translate a calculated fuel mass into an injector pulse-width value in Motec M1 programming.