Link G5 Training Course Part 72: Fail-Safe Strategies walks you through how to set-up a lean protection and oil pressure fail safe to prevent engine damage.

Link G5 Training Course Part 73: Speed Set-Up walks you through how to set-up a transmission speed and wheel speed sensors within the PCLink software.

Link G5 Training Course Part 74: Gear Set-Up walks you through how to configure and calibrate gear based detection within the PCLink software.

Link G5 Training Course Part 75: Basic Launch Control walks you through setting up a simple strategy for launch control within the PCLink software.

Link G5 Training Course Part 76: Advanced Launch Control walks you through how to dial in launch control to help traction limited vehicles in lower gears.

Link G5 Training Course Part 77: Anti-Lag Launch Control walks you through how to implement spark retard along with fuel enrichment to generate boost pressure when launching on a turbocharged engine.

Link G5 Training Course Part 78: Basic Rally Anti-Lag / IACV Based walks you through how to implement a simple rally anti-lag control using an idle control motor for airflow assistance.

Link G5 Training Course Part 79: Advanced Rally Anti-Lag / IACV + ALV Based walks you through how to set-up the rally anti-lag using a anti-lag valve along with a idle control motor for airflow assist.

Link G5 Training Course Part 80: Flame Map walks you through how to implement a flame map to generate flames from exhaust on deceleration conditions.

Link G5 Training Course Part 81: Burble / Pops & Bangs walks you through how to set-up a burble style tune using the PCLink software.

Link G5 Training Course Part 82: Flex Fuel Tuning - Modelled Mode walks you through how the flex fuel tuning feature works within the modelled fuel equation mode.

Link G5 Training Course Part 83: Flex Fuel Tuning - Traditional Mode walks you through how the flex fuel tuning works based in the traditional fuel equation mode.

Link G5 Training Course Part 84: Staged Fuel Injection walks you through how to properly program staged fuel injection control using the PCLink software.

Link G5 Training Course Part 85: DBW Pedal / Plate Set-Up walks you through how to configure and calibrate DBW sensors within the PCLink software.

Link G5 Training Course Part 86: DBW PID Tuning walks you through how to calibrate the DBW P, I, and D gains along with the feed forward duty cycle table.

Link G5 Training Course Part 87: DBW Target Tuning walks you through how to set-up the DBW targeting to achieve the best results in throttle control.

Link G5 Training Course Part 88: DBW Idle Control Tuning walks you through how the idle control routine works when drive-by-wire based.

Link G5 Training Course Part 89: Rally Anti-Lag / DBW + ALV walks you through how to set-up the rally anti-lag based around DBW and anti-lag value to achieve the best possible control.

Link G5 Training Course Part 90: VVT Cam Control Overview walks you through the fundamentals for setting up and controlling variable valve timing within the PCLink software.

Link G5 Training Course Part 91: VVT Set-Up & Tuning Demo walks you through dialing in the VVT control on a Honda K-series engine using a Mainline chassis dyno.

Link G5 Training Course Part 92: Boost Control Basics walks you through the fundamentals of boost control including an overview of a turbocharger, internal / external wastegate, boost solenoid routing, and concept of frequency / duty cycle.

Link G5 Training Course Part 93: Open-Loop Boost Control walks you through how to implement the most basic form of boost control programming within the PCLink software.

Link G5 Training Course Part 94: Closed-Loop Boost Control Set-Up walks you through how to set-up the calibration file for closed-loop control within the PCLink software.

Link G5 Training Course Part 95: Closed-Loop Boost Control Tuning walks you through how to calibrate within the closed-loop boost strategy.