HP Tuners Ford Gen 1 Coyote Training Part 28: Idle Control Tuning
HP Tuners Ford Gen 1 Coyote (2011-14) Training Course
•
1h 2m
HP Tuners Ford Gen 1 Coyote Training (2011-2014) Course Part 28 walks you through how the idle control works within the Ford Copperhead PCM programming. We demonstrate using the VCM scanner to properly log idle control channels and then using that collected data to make appropriate changes in the calibration file.
Up Next in HP Tuners Ford Gen 1 Coyote (2011-14) Training Course
-
HP Tuners Ford Gen 1 Coyote Training ...
HP Tuners Ford Gen 1 Coyote Training (2011-2014) Course Part 29 walks you through how the Otto cycle works and how spark timing applies within the Otto cycle. This is a basic tutorial to give you perspective to move into the next few tutorials for understanding and programming spark timing.
-
HP Tuners Ford Gen 1 Coyote Training ...
HP Tuners Ford Gen 1 Coyote Training (2011-2014) Course Part 30 walks you through how the spark timing programming logic works within the Ford Copperhead PCMs. We look at logged data in the VCM scanner to get a better understanding of analyzing how the spark timing and knock control work together.
-
HP Tuners Ford Gen 1 Coyote Training ...
HP Tuners Ford Gen 1 Coyote Training (2011-2014) Course Part 31 shows you a spark tuning demonstration using a NA Coyote on our chassis dyno.
8 Comments